ROYAL EDGE NON-REINFORCED FIRE RETARDANT EPDM MEMBRANE
TECHNICAL DATA SHEET
DESCRIPTION:
RPI Royal Edge Fire Rated EPDM membrane is a
non-reinforced fire retardant cured single -ply roofing
is a cured single-ply roofing membrane that can be
used in fully adhered, mechanically attached, and
ballasted systems.
PREPARATION OF SUBSTRATES:
1. Substrates must be clean, dry, smooth, and free of
sharp edges, fins, loose or foreign materials, oil,
grease, and other materials that may damage the
membrane.
2. All roughened surfaces that can damage the
membrane shall be repaired as specified to offer a
smooth substrate.
3. All surface voids greater than 1/4″ (6.3 mm) wide
shall be properly filled with an acceptable fill
material.
METHOD OF APPLICATION:
- RPI Royal Edge non-reinforced Fired Rated EPDM EPDM membrane must be installed in accordance RPI Specifications, details, and installation requirements
STORAGE:
1. Store away from sources of punctures and physical
damage.
2. Assure that structural decking will support the loads
incurred by material when stored on rooftop. The deck load
limitations should be specified by the project designer.
3. Store away from ignition sources as membrane will burn when
exposed to open flame.
PRECAUTIONS:
1. Take care when moving, transporting, handling, etc. to
avoid sources of punctures and physical damage.
2. Isolate waste products, such as petroleum products,
greases, oils (mineral and vegetable) and animal
fats from the Royal Edge EPDM membrane. Contact RPI
Technical for more specific installation recommendations.
3. Refer to Material Safety Data Sheets (MSDS) for safety
information.
